This is a short instructional video on programming the i-Cooking Induction control.

In the first edition of the manual is a wrong programming instruction is printed. The latest versions [from Rev. 100506] have the correct instructions. This manual is also available for download through the download section.

The control must be configured prior to initial use. To do this, follow these steps.

• Remove any pot from the induction elements.
• Switch of the electrical power to the appliance.
• Wait 10 seconds before switching the power back on.
• Start programming within 2 minutes after you switched on the power. Avoid using the on/off switch en use for the programming a pan with a minimum diameter off 16cm. Don't use any other pan during the programming.

Delete current configuration:

• A. Press on ”p“ and keep this pressed until the ”-“symbol flashes on all zones.
• B. Keep the switch pressed and use your other hand to, start from right below, counter clockwise, press every display [shorter than 2 seconds per display]. When you hear a double peep you have to start over again starting at A.
• C. Relieve all switches en press a few seconds on the simmerswitch, until a flashing ”E“ symbol appears.
• D. Wait until the flashing ”E“ symbol stops flashing. After a few seconds the ”E“ codes will change into ”C“ codes.
• attn.: for a configuration with 3 zones the session starts right-top instead of right-below.

New configuration:

• E. Chose a display position, by pressing the corresponding code ”C“ . Put a pan onto the desired position and wait until the code ”C“ changes into code ”-“. This  inductionelement is now teamed with the switch position.
• F. Repeat this procedure with the other induction fields. If all fields are teamed all displays will be switched off.